The Plastic Classic Forum, your free and in-depth resource for information on re/building classic sailboats. ... Be sure to visit / join our sister site at sailFar.net! ... And don't forget to check out Atom's Virtual Home Port! ...
I'm coming out of lurking mode for a minute to ask a question about bolting in my boat's chainplates.
Spurr's "Upgrading the Cruising Sailboat" states that bedding compound should be applied to chainplates and backing plates before fastening. But I've been using guidance from Tim's Glissando and daysailor projects to guide me, and I can't see that there is evidence of bedding compound on the daysailor chainplates http://www.tritondaysailor.com/images/c ... alled1.jpg
My question is this: I'm getting ready to bolt down my chainplates and wondered if I need to bed them to the knees and bulkheads?
Thanks in advance for all the awesome advice in this forum.
I don't believe I have heard of anyone doing that. I guess it might help spread the load if things were a bit uneven and I don't think there would be any harm in doing it. The covering escutcheon definately needs to be bedded though. it should be rebedded fairly frequently as well as these areas are notorious for leaking.
Figment wrote:Spurr's bedding advice pertains to external chainplates.
I didn't even pick up on this obvious fact. There's a picture in the book and everything, and I didn't see it for what it was. I'm feeling pretty stupid. Thanks for clearing this up.