![Image](http://i295.photobucket.com/albums/mm149/mdidriksen/DSC_0080.jpg)
So I thought I would show off my ignorance and ask a few questions.
Yanmar recommends using 3M 5200 to adhere this gasket to the hull. While the rubber seems quite substantial, I am concerned about using 5200 due to its relatively permanent adhesion. Are there any alternatives that would be appropriate? Or should I just stick with the 5200 and make sure that the gasket is properly pressured/clamped when the adhesive is applied (I suspect improper clamping was the original problem).
Also, what do I need to do in order to get a good bonding surface, assuming that there is a layer of 5200 already bonded to the hull, but not the gasket. The off-white stuff in the picture is adhesive, not fiberglass. Does this need to be ground off completely? Or can it be roughed up and new adhesive be applied over it?
Thanks in advance!