Hot Moulding and Fiberglass Boat Building in the '50s.

Tools you like...tools you hate...
Post Reply
Quetzalsailor
Master of the Arcane
Posts: 1100
Joined: Fri Aug 26, 2005 9:53 am
Boat Name: Quetzal
Boat Type: LeComte North East 38
Location: Philadelphia, PA

Hot Moulding and Fiberglass Boat Building in the '50s.

Post by Quetzalsailor »

The following hypertext will take you to a British Pathe film of making a Firefly dinghy out of hot moulded veneer. Look at the 12 choices along the bottom and you'll have the opportunity to watch a clip of making a fiberglass dinghy.

http://www.britishpathe.com/record.php?id=171

Amazing lack of safety equipment!

My Flying Dutchman was cold moulded; the veneers were precut and stapled to a mould containing the keel, just like the film, but the glue was Aerolite or Weldwood urea resin. I presume that the each of the Firefly veneers were different; if not, you'd have a 'constant camber' hull. My FD had veneers which were stamped with a number denoting its place on the mould.
Zach
Boat Obsession Medal Finalist
Posts: 684
Joined: Wed Jan 25, 2006 6:28 pm
Location: Beaufort, North Carolina
Contact:

Re: Hot Moulding and Fiberglass Boat Building in the '50s.

Post by Zach »

Way cool!
1961 Pearson Triton
http://pylasteki.blogspot.com/
1942 Coast Guard Cutter - Rebuild
http://83footernoel.blogspot.com/
mitiempo
Candidate for Boat-Obsession Medal
Posts: 319
Joined: Mon Oct 27, 2008 11:37 am
Boat Name: Mi Tiempo
Boat Type: Canadian Sailcraft CS27
Location: victoria bc canada

Re: Hot Moulding and Fiberglass Boat Building in the '50s.

Post by mitiempo »

Interesting video. I watched the fiberglass dinghy video as well. Other than the lack of safety equipment, the interesting comment that "because of the very nature of its construction, this type of boat can't be mass produced." Apparently that changed! Also at the end of the video, not a lifejacket to be seen.
Post Reply