I'm getting ready to install new plastic ports and have bought butyl caulk for the purpose. Can butyl caulk be smoothed in a way similar to silicone caulk? I'd like to leave a fillet of caulk around the outside of the ports, but want it to look nice. I thought I would use masking tape around the perimeter of the port and the cabin sides, lay on and smooth the caulk on both surfaces before assembly, mount the port, then smooth the excess with a finger dipped in mineral spirits. Close?
Chris Miller
butyl caulk
-
- Rough Carpentry Apprentice
- Posts: 52
- Joined: Sun Oct 29, 2006 8:38 am
- Boat Name: Moonshadow
- Boat Type: Seafarer 31 yawl
- Location: Lloyd, Florida
butyl caulk
Last edited by margitchris on Mon May 10, 2010 9:12 am, edited 1 time in total.
-
- Master of the Arcane
- Posts: 1100
- Joined: Fri Aug 26, 2005 9:53 am
- Boat Name: Quetzal
- Boat Type: LeComte North East 38
- Location: Philadelphia, PA
Re: butyl caulk
The Butyl sealant I used many years ago for copper flashing was solved and cleaned up with paint thinner. I did not leave any showing, so no fillets. It was sold for gutter sealing, never hardens, is almost as miserable to use as 3M 5200.
-
- Damned Because It's All Connected
- Posts: 2846
- Joined: Tue Apr 08, 2003 9:32 am
- Boat Name: Triton
- Boat Type: Grand Banks 42
- Location: L.I. Sound
Re: butyl caulk
Don't use it for a fillet. It will collect dust and other grime from the air for WEEKS and look like hell.
Mask well for ease of cleanup and leave the least possible amount showing.
The elastic properties of the material really obviate the need for a fillet anyway. It's not going to fail by cracking. If both surfaces are clean you'll have a good seal for as long as it matters.
Mask well for ease of cleanup and leave the least possible amount showing.
The elastic properties of the material really obviate the need for a fillet anyway. It's not going to fail by cracking. If both surfaces are clean you'll have a good seal for as long as it matters.