Search found 3 matches
- Fri Apr 03, 2020 5:14 pm
- Forum: Boatbuilding and Repair Techniques
- Topic: Ideas for Alberg 30 mast step beam support!
- Replies: 3
- Views: 1885
Re: Ideas for Alberg 30 mast step beam support!
Although my A30 did fine without it the last 53 years or so, i also figured some support wont hurt. So i deemed it sufficient to get some 2.5x3.5x8 planks, and i believe 1/4 x 7 in bolts and washers. I angled the base and top of each of the 4 support beams so they would fit as snug as possible into ...
- Fri Apr 03, 2020 4:39 pm
- Forum: Boatbuilding and Repair Techniques
- Topic: Alberg 30 Bilge Repair Help
- Replies: 6
- Views: 2493
Re: Alberg 30 Bilge Repair Help
I also just about finished my "bilge repair". Underneath all that is just the ballast embedded in some type of cement. I cut out all of the fake floor including the remainder of the old chipped ballast encapsulation, scrubbed my bilge for 4 hrs removing all oil residues, let it dry from an...
- Fri Apr 03, 2020 3:59 pm
- Forum: Questions and Answers
- Topic: Stern tube removal and rebedding
- Replies: 13
- Views: 4172
Re: Stern tube removal and rebedding
I know this post is somewhat older, but maybe someone will still reply to this before i start this discussion all over. Im also replacing my cutlass bearing on my A30. I already have removed my engine. Now my question is about alignment. The stern tube is screwed into the cutlass bearing housing, wh...