Almost getting in!

Anything goes, as long as it falls under the general forum protocol and rules.
Post Reply
cdawgs65
Deck Grunge Scrubber
Posts: 45
Joined: Thu Jul 05, 2007 8:13 am
Boat Name: Ring
Boat Type: Pearson Triton 559
Location: Pembroke Mass.
Contact:

Almost getting in!

Post by cdawgs65 » Mon Jul 15, 2013 9:39 pm

Just wanted to know if there is anybody else out there who isn't in the water yet, almost there tho! Okay just going to blow off some steam! My wife traveling for work, kids sailing lessons other obligations, work on boat not done because of crappy weather!! Okay done! Let's get pumped for
some decent weather!

Hesper(II)
Bottom Sanding Grunt
Posts: 9
Joined: Mon Dec 06, 2010 6:12 pm
Boat Name: to be named
Boat Type: Morgan 24

Re: Almost getting in!

Post by Hesper(II) » Wed Jul 17, 2013 11:31 am

Cdawg-I run into the issue of doing some project or going in every year. Once again this year I opted to go in rather than do projects I want to do. Yeah...The cabin and cockpit didn't get painted again (but I did paint inside), no, I didn't put in the portlight that broke last year(but I do get good ventilation through the open hole), no, I still haven't hooked up the sink to the new ball valve/thru hull (but I did put a new bilge pump in). But-I'm in and at least we've had a few good sails so far including a trip to the Lobster Hut in Plymouth which you probably know. The season in this crummy state is too short to worry about those little things as far as I'm concerned.

Cheers

Jim

Post Reply