Spinnaker pole fittings- Alden Challenger
Spinnaker pole fittings- Alden Challenger
I'm about to start building a wood pole by laminating up some clear spruce but as my better half pointed out may be I should find some end fitting before all the work is started. The specs from Alden call for a Merriman size 3-A, fig 450-L. I don't have exact measurements yet but I think the socket that slides over the end of the pole is around 2-3". I'd love to find some bronze ones but can only find smaller ones. I've been calling consignment stores as well (Wickford, RI) but think there must be some kicking around a spar shed some where. Any thoughts, ideas?
-
- Master of the Arcane
- Posts: 1317
- Joined: Thu Dec 28, 2006 8:50 am
- Boat Name: Hirilondë
- Boat Type: 1967 Pearson Renegade
- Location: Charlestown, RI
Re: Spinnaker pole fittings- Alden Challenger
I would listen her.JSmith wrote:I'm about to start building a wood pole by laminating up some clear spruce but as my better half pointed out may be I should find some end fitting before all the work is started.
Are you asking for sources? Or for specs?
Dave Finnegan
builder of Spindrift 9N #521 'Wingë'
--------------------------------------------------------------------------------------------------------------------------------------------------------------------
Gresham’s Law of information: Bad information drives out good. No matter how long ago a correction for a particular error may have appeared in print or online, it never seems to catch up with the ever-widening distribution of the error.
builder of Spindrift 9N #521 'Wingë'
--------------------------------------------------------------------------------------------------------------------------------------------------------------------
Gresham’s Law of information: Bad information drives out good. No matter how long ago a correction for a particular error may have appeared in print or online, it never seems to catch up with the ever-widening distribution of the error.
- Bluenose
- Candidate for Boat-Obsession Medal
- Posts: 438
- Joined: Thu Apr 05, 2007 4:19 pm
- Boat Name: Bolero
- Boat Type: Modified Shields One Design
- Location: Lopez Island, WA
- Contact:
Re: Spinnaker pole fittings- Alden Challenger
I would second this advice. I have been looking on and off for for quite a while and they seem quite rare. Maybe in the North East you will have better luck. The only suggestion I could add is to place some adds looking for a wooden spinnaker pole. It might be the best way to find old bronze end fitting.Hirilondë wrote:I would listen her.JSmith wrote:I'm about to start building a wood pole by laminating up some clear spruce but as my better half pointed out may be I should find some end fitting before all the work is started.
Are you asking for sources? Or for specs?
Good Luck
And if you happen to find a pair of fitting a bit too small, say 1/2-2 inches, I will gladly take them off your hands:).