Plastic Classic Forum

thank you !! I will take your advice and wait until its been in the water a week or so

forgot to mention: when boat was puchased a year ago it was on stands that were sitting on a lawn so more give than sitting on asphault driveway. thay actually sank in a few inches. when I ran the engine last year I don't remember any vibration. So could this be a problem (at least partial) with the...

Just about ready to launc our 1975 Bristol 32. Got the engine going today, runs mint ,put it into gear ,forward or reverse and I get a horrible vibration thru the entire boat.vibe gets worse as I increase RPM. none or little at low rpm. PO told me engine was remounted by some guy he wasn't found of....

I have a pair of kenyon 4500 traveler cars. Is there an easy way to load the bearings on the wheels ? rig rite tells me I need a car loader ??
Thanks

whats the best material to use on stainless bolts attached to a aluminum spar ??
thanks !

Hello All looking for advice on the best way to wire 4 - 6 V ,GC 2 ( 220 AH +/_ each ) for the house only. I plan on locating them (2) in the old unused ice box and (2) below where the oven used to be. This I think would kind of balance the weight side to side and keep them relitively low in the boa...

I accept the title and ad another post to my resume :)

am curious how I became a bottom sanding grunt ??? not that I would ever sand the bottom and grunt while doing so,I prefer to listen to some cool country or classic rock I wonder who hands out the covetted titles

anyone have opinons on Exide GC-5's .They are Napa 8146's and I need some inexpensive house bats. Ican get them at Napa for $139.no shipping. wanted US 2200's but don't want to eat the shipping cost. about the same ah's.
thanks